Camper Jack Not Working
Camper Jack Not Working. Some jacks are welded to the trailer; Remove the powerhead from the jackpost , and align the pin with the slot in the drive connector in the jack post and position the powerhead so that the pin fits in the slot.
I was very happy to be rid of the camper with the hyd. Being a complete newbie to rving and learning as i go, i've come across a problem. Either power is not getting to your motor, your motor is bad, or your ground connection isn't working properly.
Hey, We Had Some Trouble With Retracting Our Thor Ace Motorhome Power Leveling Jacks.
Manual mode has the ability to be a great quick fix to sort out your rv’s jack problems. It took a lot of pumping to raise it to bed height and then to lower it down to ground level was always an adventure. Remove the nut and bolt that secures the handle to the jack.
Remove The Pin Or Bolt Attaching The Jack Handle To The Body Of The Jack With Pliers Or A Socket Wrench And Take The Handle Off.
It's very possible that the battery has enough juice to send power to the motors but not enough to actually operate the jacks when under load. Screw the jack to the most extended spot the jack will go. It is sometimes almost impossible to see this bend.this can happen with electric jacks as well and results from the trailer moving either forward or backward while the jack is extended.
Look Closely To See If There Is Any Hydraulic Fluid Leaking Anywhere As Well.
The next source for this problem would be the clutch. Fasten the powerhead to the jackpost once more, and the jack should operate normally. Unbolt the jack from the trailer frame and remove it.
The Inner Extension Tube Could Be Ever So Slightly Bent.
If you see no movement but hear a clicking sound, then the clutch is. It could be from a corroded or loose ground connection either at the battery end or at the landing gear; For your electric jack, there are only three possible explanations for your jack not working with a charged battery.
The Jacks Will Lower In Pairs So You Will Have To Lower The Back Jacks First And Then The Front Ones.
For those, raise the front of the trailer with a taller jack and support it on jack stands to work on the jack. I was very happy to be rid of the camper with the hyd. If the pin is not in the slot, it will not turn the screw, which actuates the jack to move.
Post a Comment for "Camper Jack Not Working"